0418 351 120 Free quote Call

Paint or Carpet First? The
Right Order for a Renovation

17 November 2026 · 4 min read · Heathurst Coatings

A family living room with freshly repainted walls and ceiling

Paint first, then lay the new carpet. Painting walls, ceilings and doors before the carpet goes in means drips, sanding dust and ladder marks land on the old floor covering or bare boards, not your new carpet. The one exception is skirting boards: they are often given a final coat or a touch-up after the carpet is fitted, because carpet layers can scuff them.

Why is it better to paint before laying carpet?

  • No risk of paint on new carpet. Even careful painters drop the occasional splash, and paint is far harder to get out of carpet fibres than off an old floor that is being replaced anyway.
  • Ceilings drip. Ceiling painting produces fine spatter from the roller that settles across the floor.
  • Preparation is messy. Sanding, filling and scraping create dust that works its way into new carpet.
  • Ladders and equipment. Ladders, trestles and drop sheets moving around the room can mark or flatten new pile.
  • It's quicker. Painters don't have to spend as long protecting the floor, which can save time on the job.

Are there exceptions?

Skirting boards

Carpet layers use knee kickers and tools close to the skirting, and they often mark it. A common approach is to paint the skirtings fully before the carpet is installed, then touch them up afterwards. Some people prefer to leave the final skirting coat until after the carpet goes in. Either works, as long as the carpet is well protected for that last coat.

Painting only the walls in one room

If you are only freshening up one or two walls and the carpet is already booked, painting afterwards is manageable with good floor protection. It just takes more care.

Hard floors

The same logic applies to new timber, laminate and vinyl floors: paint first where you can. Polished floorboards are slightly different, because floor sanding creates a lot of fine dust. Many people sand and coat the floors first, then paint, then apply the final floor coat, but check with your floor finisher about the order they prefer.

How long should you wait between painting and new carpet?

Water-based wall paint is usually touch-dry within hours, but it takes longer to cure fully and harden. Give the paint at least a couple of days before the carpet goes in so that walls and skirtings aren't marked when furniture and carpet rolls are moved around. If enamel has been used on doors and trims, allow longer, and follow the drying and recoat times on the tin. Keep the room ventilated during this time.

What if you have to paint after the carpet is laid?

Sometimes the timing doesn't work out. If the carpet goes in first:

  • Cover the floor completely. Use heavy canvas drop sheets rather than thin plastic, which is slippery and lets paint soak through when it tears. Tape the edges of the protection along the skirtings.
  • Lay carpet protection film in walkways if trades will be coming and going.
  • Keep paint tins and trays on a board or tray, never directly on the drop sheet.
  • Have a damp cloth ready. Fresh water-based paint can often be blotted out of carpet if it is dealt with straight away. Blot, don't rub, and work from the outside of the spill inwards.
  • Avoid sanding indoors where you can, or vacuum thoroughly as you go.

Should you paint before or after other trades?

Carpet isn't the only thing to plan around. As a general rule, painting comes after the messy, structural work and before the finishes that are easy to damage:

  • Before painting: electrical and plumbing work that cuts into walls, plastering, new cornices, built-in robes and joinery, and any window or door replacements. Holes, patches and new plaster all need to be sealed and painted, so it makes sense to get them done first.
  • After painting: carpet, light fittings and switch plates, curtain rails and blinds, wall-mounted TVs and artwork, and furniture.
  • Either side, with care: kitchen benchtops and splashbacks, and tiling. The painter will need to cut in neatly against them if they go in first.

Leaving switch plates and light fittings off until after painting gives a cleaner result, because the painter can paint behind them rather than around them.

What about moving out of the house?

If you are renovating an empty house before moving in or selling, the order above is easy to follow because nothing is in the way. In an occupied home, the order still holds, but the work is usually done room by room. Painting one room and then having its carpet laid before moving on to the next keeps at least part of the house usable throughout.

What is the best order for a full room renovation?

A typical order that keeps rework to a minimum:

  1. Demolition, electrical and plumbing rough-in
  2. Plastering and repairs
  3. Ceilings, walls and doors painted
  4. Hard floors and tiling
  5. Carpet installation
  6. Skirting touch-ups and final coats
  7. Fixtures, fittings and furniture back in

Talk to your painter and carpet layer about dates early, so each trade has the room clear when they need it.

Rather have it done for you?

Heathurst paints interiors across all of greater Melbourne and plans the work around your other trades, including carpet and floor installers. Floors and furniture are covered, and we walk through the finished job with you before we leave. See our interior painting service, request a free on-site quote through our contact page, or call 0418 351 120.

Pick a colour. We'll do the rest.

0418 351 120
Get my free quote